Complementary methods to investigate the development of clogging within a horizontal sub-surface flow tertiary treatment wetland

WATER RESEARCH

卷:44

Article

Knowles, P. R.¹  Griffin, P.²  Davies, P. A.¹ 

[1] Aston Univ, Sustainable Environm Res Grp, Birmingham B4 7ET, W Midlands, England

[2] Severn Trent Water Ltd, Coventry CV3 6PR, W Midlands, England

关键词: Treatment wetlands;    Horizontal sub-surface flow;    Hydraulic conductivity;    Clogging;    Tracer tests;    Hydrodynamics;   

DOI  :  10.1016/j.watres.2009.09.028

来源: Elsevier

【 摘 要 】

A combination of experimental methods was applied at a clogged, horizontal subsurface flow (HSSF) municipal wastewater tertiary treatment wetland (TW) in the UK, to quantify the extent of surface and subsurface clogging which had resulted in undesirable surface flow. The three dimensional hydraulic conductivity profile was determined, using a purpose made device which recreates the constant head permeameter test in-situ. The hydrodynamic pathways were investigated by per-forming dye tracing tests with Rhodamine WT and a novel multi-channel, data-logging, flow through Fluorimeter which allows synchronous measurements to be taken from a matrix of sampling points. Hydraulic conductivity varied in all planes, with the lowest measurement of 0.1 m d(-1) corresponding to the surface layer at the inlet, and the maximum measurement of 1550 m d(-1) located at a 0.4 m depth at the outlet. According to dye tracing results, the region where the overland flow ceased received five times the average flow, which then vertically short-circuited below the rhizosphere. The tracer break-through curve obtained from the outlet showed that this preferential flow-path accounted for approximately 80% of the flow overall and arrived 8 h before a distinctly separate secondary flow-path. The overall volumetric efficiency of the clogged system was 71% and the hydrology was simulated using a dual-path, dead-zone storage model. It is concluded that uneven inlet distribution, continuous surface loading and high rhizosphere resistance is responsible for the clog formation observed in this system. The average inlet hydraulic conductivity was 2 m d(-1), suggesting that current European design guidelines, which predict that the system will reach an equilibrium hydraulic conductivity of 86 m d(-1), do not adequately describe the hydrology of mature systems. (C) 2009 Elsevier Ltd. All rights reserved.

【 授权许可】

Free