A Comparative Study of E-Beam Deposited Gate Dielectrics on Channel Width-Dependent Performance and Reliability of a-IGZO Thin-Film Transistors

Materials

J.W. Chang¹  DaveW. Chen¹  Gwomei Wu²  AnupK. Sahoo² 

[1] Chang Gung Memorial Hospital, Keelung 204, Taiwan;Institute of Electro-Optical Engineering, Chang Gung University, Taoyuan 333, Taiwan;

关键词: a-IGZO;    thin-film transistor;    e-beam;    gate dielectric;    reliability;   

DOI  :  10.3390/ma11122502

来源: DOAJ

【 摘 要 】

A comparative study on the effects of e-beam deposited gate dielectrics for amorphous indium gallium zinc oxide (a-IGZO) thin-film transistors (TFTs) has been carried out using SiO₂, Si₃N₄, and Ta₂O₅ dielectric materials. The channel width dependent device electrical performances were investigated using three different sizes of 500 μm, 1000 μm, and 1500 μm. The reliability characteristics were revealed by the threshold voltage variation and drain current variation under positive bias stress. The e-beam deposited high-k dielectric Ta₂O₅ exhibited the highest stability at the stress voltage of 3 V for 1000 s due to its high capacitance density at 34.1 nF/cm². The threshold voltage variation along the channel width decreased from SiO₂, then Si₃N₄, to Ta₂O₅, because of the increased insulating property and density of capacitance. The SiO₂-based a-IGZO TFT achieved a high field effect mobility of 27.9 cm²/V·s and on⁻off current ratio > 10⁷ at the lower channel width of 500 μm. The gate leakage current also decreased with increasing the channel width/length ratio. In addition, the SiO₂ gate dielectric-based a-IGZO TFT could be a faster device, whereas the Ta₂O₅ gate dielectric would be a good candidate for a higher reliability component with adequate surface treatment.

【 授权许可】

Unknown