Analysis and prediction of copper surface roughness obtained by selective laser melting

International Scientific and Practical Conference on Innovations in Engineering and Technology

工业技术;自然科学

Saprykin, A.A.^1 ; Saprykina, N.A.^1 ; Saprykin, A.A.^2

Tomsk Politechnic University, Tomsk, Russia^1

Novosibirsk State Technical University, Novosibirsk, Russia^2

关键词: Digital microscopes;    Experiment planning;    Layer by layer;    Mechanical activation;    Mechanoactivation;    Original design;    Powder material;    Selective laser melting;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/441/1/012044/pdf
DOI  :  10.1088/1757-899X/441/1/012044

来源: IOP

【 摘 要 】

The paper presents the results of experimental studies of the effect of mechanoactivation of the powder, argon shielding gas and the effect of technological modes of melting: the speed of the laser beam, the power of laser radiation, the scanning step, the preliminary temperature of heating the powder material on the surface roughness of the copper powder material obtained by selective laser melting. Experiments on the melting of copper powder are implemented on the installation of layer-by-layer laser melting of the original design, which allows to adjust all technological modes of melting. The surface roughness is determined on the non-contact digital microscope Olympus LEXT OLS4100. The mathematical dependence of the surface layer roughness of copper powder on the technological modes of melting is obtained on the basis of the theory of experiment planning and static processing of the results. The significant parameters of the regime-the power of laser radiation, the speed of the laser beam, the scanning step affecting the roughness of the layer. The positive effect of mechanical activation of powder material and protective atmosphere on the quality of the surface layer is shown.