The Fabrication of Bulk Heterojunction P3HT: PCBM Organic Photovoltaics

5th International Conference on Advanced Materials Sciences and Technology

Darwis, D.^1 ; Sesa, E.^1 ; Farhamza, D.^1 ; Iqbal^1

Centre for Organic Electronics, Tadulako University, Jl. Soekarno Hatta KM.9, Tondo, Mantikulore, Kota Palu, Sulawesi Tengah

94148, Indonesia^1

关键词: and PCBM;    Bulk heterojunction;    Heterojunction devices;    Heterojunction solar cells;    Organic photovoltaic devices;    Organic photovoltaics;    P3HT;    Poly-3-hexylthiophene;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/367/1/012029/pdf
DOI  :  10.1088/1757-899X/367/1/012029

来源: IOP

【 摘 要 】

Bulk heterojunction Organic photovoltaic (OPV) devices are gaining a lot of interest due to their potential for ease of processing and lower manufacturing cost sustainable energy generation. In consequence, the number of studies into the properties and characteristics of organic solar cell devices has been increased to improving their power conversion. A further advancement over past decade has shown that improved efficiency could be obtained by mixed of poly(3 - hexylthiophene) (P3HT) and [1] - phenyl - C61-butyric acid methyl ester (PCBM) as an active layer. A series of optimizations of this P3HT: PCBM blends, such as the mixture ratio variation, the annealing treatments, and solvent treatment, have been emerged to improve the efficiency of the OPV. As a result, significant improvements were achieved. Here, we report the fabrication heterojunction devices of 2.9 % efficiency. This result has been achieved using the configuration of a typical heterojunction solar cell modules consists of layered glass/ITO/PEDOT: PSS/active layer/cathode interlayer.