21-PWR Waste Package Side and End Impacts

Delabrosse, V.

United States. Department of Energy. Yucca Mountain Project Office.

关键词: Alloys;    36 Materials Science;    Thickness;    Yield Strength;    Wastes;   

DOI  :  10.2172/899936
RP-ID  :  000-00C-DSU0-01000-000-00B, Rev. 00B
RP-ID  :  NA
RP-ID  :  899936

美国|英语

来源: UNT Digital Library

【 摘 要 】

The objective of this calculation is to determine the structural response of a 21-Pressurized Water Reactor (PWR) spent nuclear fuel waste package impacting an unyielding surface. A range of initial velocities and initial angles between the waste package and the unyielding surface is studied. The scope of this calculation is limited to estimating the area of the outer shell (OS) where the residual stress exceeds a given limit (hereafter ''damaged area''). The stress limit is defined as a fraction of the yield strength of the OS material, Alloy 22 (SB-575 N06022), at the appropriate temperature. The design of the 21-PWR waste package used in this calculation is that defined in Reference 8. However, a value of 4 mm was used for the gap between the inner shell and the OS, and the thickness of the OS was reduced by 2 mm. The sketch in Attachment I provides additional information not included in Reference 8. All obtained results are valid for this design only. This calculation is associated with the waste package design and was performed by the Specialty Analyses and Waste Package Design Section. The waste package (i.e. uncanistered spent nuclear fuel disposal container) is classified as Quality Level 1.