Dynamic fracture of concrete - compact tension specimen

INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES

卷:48

Article

Ozbolt, Josko¹  Sharma, Akanshu²  Reinhardt, Hans-Wolf¹ 

[1] Univ Stuttgart, Inst Construct Mat, D-70560 Stuttgart, Germany

[2] Bhabha Atom Res Ctr, Reactor Safety Div, Bombay 400085, Maharashtra, India

关键词: Concrete;    Compact tension specimen;    Dynamic fracture;    Rate sensitivity;    Crack branching;    Finite element analysis;    Microplane model;   

DOI  :  10.1016/j.ijsolstr.2011.01.033

来源: Elsevier

【 摘 要 】

The behavior of concrete structures is strongly influenced by the loading rate. Compared to quasi-static loading concrete loaded by impact loading acts in a different way. First, there is a strain-rate influence on strength, stiffness, and ductility, and, second, there are inertia forces activated. Both influences are clearly demonstrated in experiments. Moreover, for concrete structures, which exhibit damage and fracture phenomena, the failure mode and cracking pattern depend on loading rate. In general, there is a tendency that with the increase of loading rate the failure mode changes from mode-I to mixed mode. Furthermore, theoretical and experimental investigations indicate that after the crack reaches critical speed of propagation there is crack branching. The present paper focuses on 3D finite-element study of the crack propagation of the concrete compact tension specimen. The rate sensitive microplane model is used as a constitutive law for concrete. The strain-rate influence is captured by the activation energy theory. Inertia forces are implicitly accounted for through dynamic finite element analysis. The results of the study show that the fracture of the specimen strongly depends on the loading rate. For relatively low loading rates there is a single crack due to the mode-I fracture. However, with the increase of loading rate crack branching is observed. Up to certain threshold (critical) loading rate the maximal crack velocity increases with increase of loading rate, however, for higher loading rates maximal velocity of the crack propagation becomes independent of the loading rate. The critical crack velocity at the onset of crack branching is found to be approximately 500 m/s. (C) 2011 Elsevier Ltd. All rights reserved.

【 授权许可】

Free