Continuous Wave Laser Nanowelding Process of Ag Nanowires on Flexible Polymer Substrates

Nanomaterials

Li Xu¹  Wei-Chia Weng¹  Ying-Chin Yeh¹ 

[1] Department of Mechanical Engineering, National Taiwan University, Taipei 10617, Taiwan;

关键词: laser nanowelding;    Ag nanowires;    transparent conductive electrode;    flexible device;   

DOI  :  10.3390/nano11102511

来源: DOAJ

【 摘 要 】

In this paper we present the laser nanowelding process of silver nanowires (AgNWs) deposited on flexible polymer substrates by continuous wave (CW) lasers. CW lasers are cost-effective and can provide moderate power density, somewhere between nanosecond pulsed lasers and flash lamps, which is just enough to perform the nanowelding process efficiently and does not damage the nanowires on the polymer substrates. Here, an Nd:YAG CW laser (wavelength 532 nm) was used to perform the nanowelding of AgNWs on polyethylene terephthalate (PET) substrates. Key process parameters such as laser power, scan speed, and number of scans were studied and optimized, and mechanisms of observed phenomena are discussed. Our best result demonstrates a sheet resistance of 12 ohm/squ with a transmittance at λ = 550 nm of 92% for AgNW films on PET substrates. A transparent resistive heater was made, and IR pictures were taken to show the high uniformity of the CW laser nanowelded AgNW film. Our findings show that highly effective and efficient nanowelding can be achieved without the need of expensive pulse lasers or light sources, which may contribute to lower the cost of mass producing AgNWs on flexible substrates.

【 授权许可】

Unknown