Polymer Testing | |
Effect of plasma treatment on the surface properties of polylactic acid films | |
Margarita Hierro-Oliva1  Amparo M. Gallardo-Moreno2  M. Luisa González-Martín3  Verónica Luque-Agudo3  | |
[1] Networking Research Center on Bioengineering, Biomaterials and Nanomedicine (CIBER-BBN), Badajoz, Spain;University Institute of Extremadura Sanity Research (INUBE), Badajoz, Spain;Department of Applied Physics, University of Extremadura, Badajoz, Spain; | |
关键词: Ar plasma; O2 plasma; Polylactic acid; Surface properties; | |
DOI : | |
来源: DOAJ |
【 摘 要 】
Plasma treatment is one of the methods currently used to obtain polymeric materials with surface properties appropriate to the functionality for which they were designed. However, the effects achieved after surface modification are not always long lasting and involve chemical and physical changes in the outermost layer. In this context, the effects of both argon and oxygen plasma on polylactic acid (PLA) films deposited on titanium were studied to determine which physical and chemical processes occur at the surface, and their duration. Regarding physical surface changes, there were scarcely any differences between both plasmas: roughness was very similar after treatments, root mean square height (Sq) being 10 times higher than the control, without plasma. Water contact angle (WCA) showed that the surface became more hydrophilic after application of the plasma, although hydrophilization was longer lasting in the case of argon treatment.With regard to chemical changes, it was observed that the argon plasma treatment caused greater fragmentation of the polymer chains, and increased crosslinking between them. ToF-SIMS analysis made it possible to propose mechanisms to explain the formation of the fragments observed.
【 授权许可】
Unknown