THERMOVISUAL MEASUREMENTS OF 3D PRINTING OF ABS AND PLA FILAMENTS

Advances in Sciences and Technology

Magdalena Paśnikowska-Łukaszuk¹  Łukasz Zgryza¹  Anna Raczyńska¹ 

[1] Lublin University of Technology, ul. Nadbystrzycka 38, 20-618 Lublin, Poland;

关键词: ABS;    PLA;    thermovisual measurement;    FDM;   

DOI  :  10.12913/22998624/94325

来源: DOAJ

【 摘 要 】

This paper presents the use of 3D printing and discusses two types of materials used in 3D printing, ie ABS (Acrylonitrile butadiene styrene) and PLA (Polylactide).Next, presents thermovisual measurement were carried out on 3D printed samples (FDM method - fused deposition modelling) of these materials. The temperature zones that occurred during printing were determined. The geometrical dimensions of samples from the same material that were printed under different conditions were compared. The height of the printed object has a large influence on the temperature distribution on its surface and The printing time does not differ significantly when printing from PLA and ABS.

【 授权许可】

Unknown