Design of a 1 DOF MEMS motion stage for a parallel plane geometry rheometer

Electronics

卷:19

Yong-Sik Kim¹  Nicholas G. Dagalakis¹  Chiara Ferraris¹  Svetlana Avramov-Zamurovic² 

[1] National Institute of Standards and Technology;

[2] Weapons and System Department United States Naval Academy;

关键词: MEMS;    motion stage;    electrothermal actuator;    rheology;    cement paste;   

DOI  :  10.7251/ELS1519045K

来源: DOAJ

【 摘 要 】

Rotational rheometers are used to measure paste properties, but the test would take too long to be useful for quality control (QC) on the job site. In this paper, a new type of rheometer is proposed based on a one degree of freedom (DOF) micro-electro-mechanical systems (MEMS)-based motion stage. Preliminary data will be presented to show the capability of the system to measure the viscoelastic properties of a paste. The parallel plate geometry rheometer consists of two plates, which move relative to each other to apply a strain to the material to be tested. From the stress measured and the strain applied, the rheological characteristics of the material can be calculated. The new device consists of an electrothermal actuator and a motion plate. For the rheological measurements, the device is designed to generate the shear stress up to 60 Pa and maintain its stiffness to less than 44 N/m. With these features, the device uses a square plate of 1.5 mm x 1.5 mm to provide enough area for a few microliter level volumes. The motion of the square plate is monitored by a capacitive sensor at the end of the oscillating plate which has a resolution of 1.06 µm. When a reference cementitious paste, Standard Reference Material (SRM)-2492, is placed between the oscillating plate of the presented motion stage and a fixed plate, the reduction in the displacement of the oscillating plate is monitored showing that the presented motion stage is reasonably designed to detect the response of the reference cementitious paste.

【 授权许可】

Unknown