Mechanical properties of structures produced by 3D printing from composite materials

MATEC Web of Conferences

卷:254

Sága Milan¹  Sapietová Alžbeta¹  Vaško Milan¹  Bárnik František¹  Handrik Marián¹ 

[1] University of Zilina, Faculty of Mechanical Engineering;

关键词: composite material;    composite structures;    3D printing;    mechanical properties;    Onyx;   

DOI  :  10.1051/matecconf/201925401018

来源: DOAJ

【 摘 要 】

By 3D printing it is possible to create different structures with different fiber-laying directions. These structures can be created depending on the type of 3D printer and its software. The Mark Two printer allows printing Onyx, a material based on nylon in combination with microcarbon fibers. Onyx can be used alone or reinforced with kevlar, glass or carbon fibers. This article deals with 3D printing and evaluation of mechanical properties of printed samples.

【 授权许可】

Unknown