Effect of mechanical disruption on the effectiveness of three reactors used for dilute acid pretreatment of corn stover Part 2: morphological and structural substrate analysis

Biotechnology for Biofuels

Peter N Ciesielski¹  Wei Wang¹  Xiaowen Chen²  Todd B Vinzant¹  Melvin P Tucker²  Stephen R Decker¹  Michael E Himmel¹  David K Johnson¹  Bryon S Donohoe¹ 

[1] Biosciences Center, National Renewable Energy Laboratory, 15013 Denver West Parkway, Golden, CO, 80401, USA

[2] National Bioenergy Center, National Renewable Energy Laboratory, Golden, CO, USA

关键词: Nanofibrillation;    Delamination;    Quantitative image analysis;    Severity factor;    Dilute acid pretreatment;    Biomass conversion;   

Others  :  792939
DOI  :  10.1186/1754-6834-7-47

 received in 2013-11-27, accepted in 2014-03-17,  发布年份 2014

【 摘 要 】

Background

Lignocellulosic biomass is a renewable, naturally mass-produced form of stored solar energy. Thermochemical pretreatment processes have been developed to address the challenge of biomass recalcitrance, however the optimization, cost reduction, and scalability of these processes remain as obstacles to the adoption of biofuel production processes at the industrial scale. In this study, we demonstrate that the type of reactor in which pretreatment is carried out can profoundly alter the micro- and nanostructure of the pretreated materials and dramatically affect the subsequent efficiency, and thus cost, of enzymatic conversion of cellulose.

Results

Multi-scale microscopy and quantitative image analysis was used to investigate the impact of different biomass pretreatment reactor configurations on plant cell wall structure. We identify correlations between enzymatic digestibility and geometric descriptors derived from the image data. Corn stover feedstock was pretreated under the same nominal conditions for dilute acid pretreatment (2.0 wt% H₂SO₄, 160°C, 5 min) using three representative types of reactors: ZipperClave® (ZC), steam gun (SG), and horizontal screw (HS) reactors. After 96 h of enzymatic digestion, biomass treated in the SG and HS reactors achieved much higher cellulose conversions, 88% and 95%, respectively, compared to the conversion obtained using the ZC reactor (68%). Imaging at the micro- and nanoscales revealed that the superior performance of the SG and HS reactors could be explained by reduced particle size, cellular dislocation, increased surface roughness, delamination, and nanofibrillation generated within the biomass particles during pretreatment.

Conclusions

Increased cellular dislocation, surface roughness, delamination, and nanofibrillation revealed by direct observation of the micro- and nanoscale change in accessibility explains the superior performance of reactors that augment pretreatment with physical energy.

【 授权许可】

   
2014 Ciesielski et al.; licensee BioMed Central Ltd.

【 图 表 】

Figure 1.

Figure 2.

Figure 3.

Figure 4.

Figure 5.

Figure 6.

【 参考文献 】

• [1]Graham-Rowe D: Beyond food versus fuel. Nature 2011, 474:S6-S8.
• [2]Himmel ME, Ding SY, Johnson DK, Adney WS, Nimlos MR, Brady JW, Foust TD: Biomass recalcitrance: engineering plants and enzymes for biofuels production. Science 2007, 315:804-807. A published erratum appears in Science 2007, 316:982
• [3]Baldwin RM, Magrini-Baira KA, Nimlos MR, Pepiot P, Donohoe BS, Hensley JE, Phillips SD: Current research on thermochemical conversion of biomass at the national renewable energy laboratory. Appl Catal B-Environ 2012, 115:320-329.
• [4]Tao L, Aden A, Elander RT, Pallapolu VR, Lee YY, Garlock RJ, Balan V, Dale BE, Kim Y, Mosier NS, Ladisch MR, Falls M, Holtzapple MT, Sierra R, Shi J, Ebrik MA, Redmond T, Yang B, Wyman CE, Hames B, Thomas S, Warner RE: Process and technoeconomic analysis of leading pretreatment technologies for lignocellulosic ethanol production using switchgrass. Bioresour Technol 2011, 102:11105-11114.
• [5]Donohoe BS, Decker SR, Tucker MP, Himmel ME, Vinzant TB: Visualizing lignin coalescence and migration through maize cell walls following thermochemical pretreatment. Biotechnol Bioeng 2008, 101:913-925.
• [6]Chundawat SPS, Donohoe BS, Sousa LD, Elder T, Agarwal UP, Lu FC, Ralph J, Himmel ME, Balan V, Dale BE: Multi-scale visualization and characterization of lignocellulosic plant cell wall deconstruction during thermochemical pretreatment. Energ Environ Sci 2011, 4:973-984.
• [7]Stickel JJ, Knutsen JS, Liberatore MW, Luu W, Bousfield DW, Klingenberg DJ, Scott CT, Root TW, Ehrhardt MR, Monz TO: Rheology measurements of a biomass slurry: an inter-laboratory study. Rheol Acta 2009, 48:1005-1015.
• [8]Viamajala S, McMillan JD, Schell DJ, Elander RT: Rheology of corn stover slurries at high solids concentrations - effects of saccharification and particle size. Bioresour Technol 2009, 100:925-934.
• [9]Donaldson LA: Lignification and lignin topochemistry - an ultrastructural view. Phytochemistry 2001, 57:859-873.
• [10]Sachs IB, Leatham GF, Myers GC, Wegner TH: Distinguishing characteristics of biomechanical pulp. Tappi J 1990, 73:249-254.
• [11]Jeoh T, Ishizawa CI, Davis MF, Himmel ME, Adney WS, Johnson DK: Cellulase digestibility of pretreated biomass is limited by cellulose accessibility. Biotechnol Bioeng 2007, 98:112-122.
• [12]Jeoh T, Johnson DK, Adney WS, Himmel ME: Cellulase accessibility of dilute-acid pretreated corn stover. Abstr Pap Am Chem Soc 2005, 230:U1682-U1682.
• [13]Donohoe BS, Vinzant TB, Elander RT, Pallapolu VR, Lee YY, Garlock RJ, Balan V, Dale BE, Kim Y, Mosier NS, Ladisch MR, Falls M, Holtzapple MT, Sierra-Ramirez R, Shi J, Ebrik MA, Redmond T, Yang B, Wyman CE, Hames B, Thomas S, Warner RE: Surface and ultrastructural characterization of raw and pretreated switchgrass. Bioresour Technol 2011, 102:11097-11104.
• [14]Igathinathane C, Pordesimo LO, Columbus EP, Batchelor WD, Methuku SR: Shape identification and particles size distribution from basic shape parameters using ImageJ. Comput Electron Agric 2008, 63:168-182.
• [15]Schneider CA, Rasband WS, Eliceiri KW: NIH Image to ImageJ: 25 years of image analysis. Nat Methods 2012, 9:671-675.
• [16]Jang HF, Seth RS, Wu CB, Chan BK: Determining the transverse dimensions of fibers in wood using confocal microscopy. Wood Fiber Sci 2005, 37:615-628.
• [17]Travis AJ, Hirst DJ, Chesson A: Automatic classification of plant cells according to tissue type using anatomical features obtained by the distance transform. Ann Bot 1996, 78:325-331.
• [18]Younes L: Shapes and diffeomorphisms. Springer; 2010. Vol. 171
• [19]Banerjee S, Yang RM, Courchene CE, Conners TE: Scanning electron microscopy measurements of the surface roughness of paper. Ind Eng Chem Res 2009, 48:4322-4325.
• [20]Ponz E, Ladaga JL, Bonetto RD: Measuring surface topography with scanning electron microscopy. I. EZElmage: a program to obtain 3D surface data. Microsc Microanal 2006, 12:170-177.