Effect of Welding Process on Microstructure, Mechanical and Pitting Corrosion Behaviour of 2205 Duplex Stainless Steel Welds

International Conference on Recent Advances in Materials, Mechanical and Civil Engineering

材料科学;机械制造;土木建筑工程

Mohammed, Raffi^1 ; Madhusudhan Reddy, G.^2 ; Srinivasa Rao, K.^3

Department of Metallurgical and Materials Engineering, NIT, Andhra Pradesh, India^1

Defence Metallurgical Research Laboratory, Hyderabad, India^2

Department of Metallurgical Engineering, Andhra University, Visakhapatnam, India^3

关键词: 2205 duplex stainless steel;    3.5% nacl solutions;    Arc constrictions;    Corrosion behaviour;    Electrochemical systems;    Gas tungsten arc welding;    Microstructural changes;    Microstructural morphology;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/330/1/012026/pdf
DOI  :  10.1088/1757-899X/330/1/012026

来源: IOP

【 摘 要 】

An attempt has been made to weld 2205 Duplex stainless steel of 6mm thick plate using conventional gas tungsten arc welding (GTAW) and activated gas tungsten arc welding (A- GTAW) process using silica powder as activated flux. Present work is aimed at studying the effect of welding process on depth of penetration, width of weld zone of 2205 duplex stainless steel. It also aims to observe the microstructural changes and its effect on mechanical properties and pitting corrosion resistance of 2205 duplex stainless steel welds. Metallography is done to observe the microstructural changes of the welds using image analyzer attached to the optical microscopy. Hardness studies, tensile and ductility bend tests were evaluated for mechanical properties. Potentio-dynamic polarization studies were carried out using a basic GillAC electro-chemical system in 3.5% NaCl solution to observe the pitting corrosion behaviour. Results of the present investigation established that increased depth of penetration and reduction of weld width in a single pass by activated GTAW with the application of SiO2flux was observed when compared with conventional GTAW process. It may be attributed to the arc constriction effect. Microstructure of the weld zones for both the welds is observed to be having combination of austenite and delta ferrite. Grain boundary austenite (GBA) with Widmanstatten-type austenite (WA) of plate-like feature was nucleated from the grain boundaries in the weld zone of A-GTAW process. Mechanical properties are relatively low in activated GTAW process and are attributed to changes in microstructural morphology of austenite. Improved pitting corrosion resistance was observed for the welds made with A-GTAW process.