2017 5th International Conference on Mechanical Engineering, Materials Science and Civil Engineering | |
The design and test of collecting device and film purge device joint work of residual film recovery machine based on Solidworks & Adams | |
机械制造;材料科学;土木建筑工程 | |
Zhai, Haozhou^1 ; Jian, Jianming^1 ; Hou, Shulin^1 ; San, Yunlong^1 ; Guo, Wensong^1 ; Sun, Yue^1 ; Gao, Mingqing^1 | |
College of Engineering, China Agricultural University, Qinghuadonglu, Haidian Disrict, Beijing, China^1 | |
关键词: Design and tests; Device design; Device parameters; Residual films; SolidWorks; Whole machine; | |
Others : https://iopscience.iop.org/article/10.1088/1757-899X/324/1/012029/pdf DOI : 10.1088/1757-899X/324/1/012029 |
|
来源: IOP | |
【 摘 要 】
The twine of residual film is an essential issue in the process of remnant residue recovery of the residual film recovery machine. It is difficult to clean up the residual film in the residual film recovery operation and to influence the subsequent film efficiency. Therefore, in response to this problem a composite tooth pocket residual film recovery device was designed. In this paper, the structure of the film recovery device design, theoretical analysis, simulation experiments, get the most appropriate film recovery device parameters. In addition, the residual film rate of the membrane is dramatically low, reaching about 1.3% only, and the operation of the whole machine is smoother, and the stability of the work is promoted. The operation of the film recovery device is very obvious. Lifting, in addition to the film rate has also been significantly improved to 93.88%
【 预 览 】
Files | Size | Format | View |
---|---|---|---|
The design and test of collecting device and film purge device joint work of residual film recovery machine based on Solidworks & Adams | 487KB | download |