Investigation of aluminum heat sink design with thermoelectric generator

3rd International Conference on Mechanical, Automotive and Aerospace Engineering 2016

机械制造;无线电电子学;航空航天工程

Mohiuddin, A.K.M.^1 ; Ameer, Muhammad Yazid^1 ; Rahman, Ataur^1 ; Khan, Ahsan Ali^2

Department of Mechanical Engineering, Kulliyyah of Engineering, International Islamic University, Malaysia, P.O.Box 10, Kuala Lumpur

50728, Malaysia^1

Department of Manufacturing and Materials Engineering, Kulliyyah of Engineering, International Islamic University, Malaysia, P.O.Box 10, Kuala Lumpur

50728, Malaysia^2

关键词: Bismuth telluride;    Circular tubes;    Heat sink design;    Peltier module;    System modelling;    Thermal conversion;    Thermo-electric generators;    Thermo-electric modules;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/184/1/012062/pdf
DOI  :  10.1088/1757-899X/184/1/012062

学科分类：航空航天科学

来源: IOP

【 摘 要 】

This paper presents an investigation of aluminium heat sink designs with thermoelectric generator. Basically, for thermoelectric generator (Peltier module), the thermal conversion uses Peltier effect. Two heat sinks with different design, with thermoelectric module of Bismuth Telluride, Bi2Te3were used in this investigation. The simulation and experimental studies were conducted with two different heat sinks attached with thermoelectric generator (TEG). System modelling was used to collect data and to predict the behaviour and performance of thermoelectric modules. Experiment was conducted in exhaust system at muffler section since the temperature at muffler section meets the requirement of thermoelectric generator.The result of the experiments shows that rectangular fin heat sink is more efficient in heat transfer compared to circular tube fin heat sink due to its geometry and properties.