Preparation of Activated Carbon from Palm Shells using KOH and ZnCl2 as the Activating Agent

1st Annual Applied Science and Engineering Conference

工业技术;自然科学

Yuliusman^1 ; Nasruddin^2 ; Afdhol, M.K.^1 ; Amiliana, R.A.^1 ; Hanafi, A.^1 ; Rachmanda, B.^1

Chemical Engineering Department, University of Indonesia, KampusBaru UI Depok, Indonesia^1

Mechanical Engineering Department, University of Indonesia, KampusBaru UI Depok, Indonesia^2

关键词: Activating agents;    Active agents;    Impurities in;    Industrial standards;    Iodine number;    Physical activation;    Potential sources;    Research results;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/180/1/012282/pdf
DOI  :  10.1088/1757-899X/180/1/012282

来源: IOP

【 摘 要 】

Palm shell is a potential source of raw materials for the produce of activated carbon as biosorbent for quite large numbers. The purpose of this study is to produce activated carbon qualified Indonesian Industrial Standard (SNI), which will be used as biosorbent to purify the impurities in the off gas petroleum refinery products. Stages of manufacture of activated carbon include carbonization, activation of chemistry and physics. Carbonization of activated carbon is done at a temperature of 400°C followed by chemical activation with active agent KOH and ZnCl2. Then the physical activation is done by flowing N2gas for 1 hour at 850°C and followed by gas flow through the CO2for 1 hour at 850°C. Research results indicate that activation of the active agent KOH produce activated carbon is better than using the active agent ZnCl2.The use of KOH as an active agent to produce activated carbon with a water content of 13.6%, ash content of 9.4%, iodine number of 884 mg/g and a surface area of 1115 m2/g. While the use of ZnCl2 as the active agent to produce activated carbon with a water content of 14.5%, total ash content of 9.0%, iodine number 648 mg/g and a surface area of 743 m2/gram.