Features of plastics edge cutting machining

International Conference on Mechanical Engineering, Automation and Control Systems 2015

机械制造;无线电电子学;计算机科学

Handozhko, A.V.^1 ; Shcherbakov, A.N.^1 ; Zaharov, L.A.^1 ; Gavrilenko, T.V.^1

Bryansk State Technical University, 7, 50 years of October st., Bryansk

241035, Russia^1

关键词: Edge cuttings;    Electrical insulators;    Machining conditions;    Quality parameters;    Technological conditions;    Thermoplastic materials;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/124/1/012155/pdf
DOI  :  10.1088/1757-899X/124/1/012155

学科分类：计算机科学（综合）

来源: IOP

【 摘 要 】

This article describes the features of pieces from thermoplastic materials in the form of electrical insulators cut by a disk edge tool. The problems in question are possible defects arising during machining and technological conditions that reduce their quantity. The necessity of required machining conditions matching substantiated in accordance with a specific grade of the material which is treated. Equipment and machining attachments, developed for experimental studies, determine the rational conditions of plastic electrical insulators machining. As a result of experiments the dependences of cut face quality parameters of plastics are obtained by machining conditions. The obtained results allowed us to make valid conclusions and recommendations.