Thermal Design of a Thermoelectric Micro-Generator

15th International Conference on Micro and Nanotechnology for Power Generation and Energy Conversion Applications

物理学;能源学

Hama, S.^1 ; Yabuki, T.^1 ; Tranchant, L.^1 ; Miyazaki, K.^1

Department of Mechanical and Control Engineering, Kyushu Institute of Technology, 1-1 Sensui-cho, Kitakyushu, Tobata-ku, Fukuoka

804-8550, Japan^1

关键词: Heat source temperatures;    Temperature differences;    Thermo-electric modules;    Thermoelectric devices;    Thermoelectric micro-generator;    Thermoelectric performance;    Thermoelectric thin films;    Vacuum deposition method;   

Others  :  https://iopscience.iop.org/article/10.1088/1742-6596/660/1/012088/pdf
DOI  :  10.1088/1742-6596/660/1/012088

来源: IOP

【 摘 要 】

In this study, we fabricated micro thermoelectric power generator using freestanding film substrate, and we evaluated the performance of the generator from the standpoint of thermoelectric performance and thermal design. We fabricated a SiNxfree-standing film substrate about 5 μm thick on Si wafer, using MEMS processes. Then, we prepared for both p and n type of bismuth telluride thermoelectric thin films by using a coaxial type vacuum arc evaporation method, and annealed for one hour at 573 K. As an electrode, Cu was deposited using a vacuum deposition method. We fabricated the thermoelectric power generator of 5 mm × 5 mm using a shadow mask for the patterning. The fabricated generator can create temperature difference of 22.3 K due to its high thermal resistance of the structure when the heat source temperature is 373 K. The exergy of the thermoelectric device is up to 7%. Therefore, the generator can convert about 0.4% of thermal energy into electric energy, even though the material performance is low with ZT = 0.28. The conversion efficiency is much higher than that of the conventional Π type thermoelectric module. It was possible to get higher performance by the thermal design, which is a more simple way than an improvement of ZT.