Hysteresis loops validation using hysteres program for corner beam-column joints under lateral cyclic loading

National Colloquium on Wind and Earthquake Engineering

Nor Hayati, A.H.^1 ; Nurfarhana Diyana, A.H.^2 ; Hayati, A.^3

Institute for Infrastructure Engineering and Sustainable Management (IIESM), Shah Alam, Malaysia^1

Faculty of Civil Engineering, Universiti Teknologi MARA, Shah Alam, Malaysia^2

Faculty of Civil Engineering and Earth Resources, Universiti Malaysia Pahang, Malaysa, Malaysia^3

关键词: Beam-column joints;    Earthquake excitation;    Equivalent viscous damping;    Experimental loop;    Hysteresis modeling;    Pre-cast;    RC buildings;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/244/1/012022/pdf
DOI  :  10.1088/1755-1315/244/1/012022

来源: IOP

【 摘 要 】

This paper presents the comparison of experimental and modelling of hysteresis loops for a corner beam-column joint under lateral cyclic loading. The beam-column joint is a sub-assemblage of a two-story precast school building. The modelled hysteresis loops were carried out using HYSTERES Program using IHYST 44 rule which is under the Ruamoko 2D folder. Modelling of hysteresis loop is one of the important processes in determining the right hysteresis model to be used in predicting the performance of the whole RC building under different level of earthquake excitations. The validation was made by determining the parameters required based on experimental loops and comparing the hysteresis loops and it response in terms of ductility, stiffness and equivalent viscous damping which obtained from both experimental and modelled hysteresis loops. It was found that the program was able to give a good agreement between them with percentage different between 2.68% and 28.49%.