Helicopter Blade Tip Vortex Modifications in Hover Using Piezoelectrically Modulated Blowing

Piezoelectric actuation;Active flow control;CFD rotor wake;Rotor blade tip vortices;Unsteady modulated blowing

Vasilescu, Roxana ; Aerospace Engineering

University:Georgia Institute of Technology

Department:Aerospace Engineering

关键词: Piezoelectric actuation;    Active flow control;    CFD rotor wake;    Rotor blade tip vortices;    Unsteady modulated blowing;   

Others  :  https://smartech.gatech.edu/bitstream/1853/4896/1/vasilescu_roxana_200412_phd.pdf

美国|英语

来源: SMARTech Repository

【 摘 要 】

Aeroacoustic investigations regarding different types of helicopter noise have indicated that the most annoying noise is caused by impulsive blade surface pressure changes in descent or forward flight conditions.Blade Vortex Interaction (BVI) is one of the main phenomena producing significant impulsive noise by the unsteady fluctuation in blade loading due to the rapid change of induced velocity field during interaction with vortices shed from previous blades.The tip vortex core structure and the blade vortex miss distance were identified as having a primary influence on BVI.In this thesis, piezoelectrically modulated and/or vectored blowing at the rotor blade tip is theoretically investigated as an active technique for modifying the structure of the tip vortex core as well as for increasing blade vortex miss distance.The mechanisms of formation and convection of rotor blade tip vortices up to and beyond 360 degrees wake age are described based on the CFD results for the baseline cases of a hovering rotor with rounded and square tips.A methodology combining electromechanical and CFD modeling is developed and applied to the study of a piezoelectrically modulated and vectored blowing two-dimensional wing section.The thesis is focused on the CFD analysis of rotor flow with modulated tangential blowing over a rounded blade tip, and with steady mid-plane blade tip blowing, respectively.Computational results characterizing the far-wake flow indicate that for steady tangential blowing the miss distance can be doubled compared to the baseline case, which may lead to a significant reduction in BVI noise level if this trend shown in hover can be replicated in low speed forward flight.Moreover, near-wake flow analysis show that through modulated blowing a higher dissipation of vorticity can be obtained.