Comparison of Machining with Long-Pulse Green and Ultrashort Pulse Lasers.

Wynne, A. E. ; Stuart, B. C.

Technical Information Center Oak Ridge Tennessee

关键词: Lasers;    Ablation;    Electron microscopy;    Machining;    Penetration;   

RP-ID  :  DE200415007282

学科分类：工程和技术（综合）

美国|英语

来源: National Technical Reports Library

【 摘 要 】

LLNL measured the material removal rate from stainless steel, silicon carbide, rhenium, N5, hastalloy X, and titanium as a function of pulse fluence at a wavelength of 810 nm for pulse durations of 150 fs, 1.5 ps, 20 ps, and 500 ps. Measurements included electron microscopy of selected samples. The experiments in I were repeated for all materials but select pulse durations with the sample in a vacuum of base pressure 10 mTorr to determine if hole quality and ablation rate is improved. LLNL measured material removal rate from stainless steel, silicon carbide, rhenium, N5, hastalloy X, and titanium as a function of pulse fluence at a wavelength of 532 nm for pulse duration at 200 ns.