Technique for Monitoring Fast Tuner Piezoactuator Preload Forces for Superconducting RF Cavities.

Pischalnikov, Y. ; Branlrd, J. ; Carcagno, R. ; Carcagno, B. ; Chase, B.

Technical Information Center Oak Ridge Tennessee

关键词: Superconducting cavity resonators;    Monitoring;    Tuning;    Rf systems;    Piezoelectricity;   

RP-ID  :  DE2007912639

学科分类：工程和技术（综合）

美国|英语

来源: National Technical Reports Library

【 摘 要 】

The technology for mechanically compensating Lorentz Force detuning in superconducting RF cavities has already been developed at DESY. One technique is based on commercial piezoelectric actuators and was successfully demonstrated on TESLA cavities. Piezo actuators for fast tuners can operate in a frequency range up to several kHz; however, it is very important to maintain a constant static force (preload) on the piezo actuator in the range of 10 to 50% of its specified blocking force. Determining the preload force during cool-down, warm-up, or re-tuning of the cavity is difficult without instrumentation, and exceeding the specified range can permanently damage the piezo stack. A technique based on strain gauge technology for superconducting magnets has been applied to fast tuners for monitoring the preload on the piezoelectric assembly. The design and testing of piezo actuator preload sensor technology is discussed. Results from measurements of preload sensors installed on the tuner of the Capture Cavity II (CCII) tested at FNAL are presented. These results include measurements during cool-down, warm-up, and cavity tuning along with dynamic Lorentz force compensation.