The Design of a RapidDischarge Varistor System for the MICE Magnet Circuits

Green, Michael A.

关键词: 72;    AVAILABILITY;    CABLES;    DESIGN;    FOCUSING;    MAGNET COILS;    MAGNETS;    QUENCHING;    RESISTORS;    SEMICONDUCTOR RESISTORS;    SOLENOIDS;    SUPERCONDUCTING COILS;    WATER;   

DOI  :  10.2172/938523
RP-ID  :  LBNL-900E
PID  :  OSTI ID: 938523
Others  :  TRN: US0806106

美国|英语

来源: SciTech Connect

【 摘 要 】

The need for a magnet circuit discharge system, in order to protect the magnet HTS leads during a power failure, has been discussed in recent MICE reports [1], [2]. In order to rapidly discharge a magnet, one has to put enough resistance across the lead. The resistance in this case is varistor that is put across the magnet in the event of a power outage. The resistance consists of several diodes, which act as constant voltage resistors and the resistance of the cables connecting the magnets in the circuit to each other and to the power supply. In order for the rapid discharge system to work without quenching the magnets, the voltage across the magnets must be low enough so that the diodes in the quench protection circuit don't fire and cause the magnet current to bypass the superconducting coils. It is proposed that six rapid discharge varistors be installed across the three magnet circuits the power the tracker solenoids, which are connected in series. The focusing magnets, which are also connected in series would have three varistors (one for each magnet). The coupling magnets would have a varistor for each magnet. The peak voltage that is allowed per varistor depends on the number of quench protection diodes that make up the quench protection circuit for each magnet coil circuit. It is proposed that the varistors be water cooled as the magnet circuits are being discharged through them. The water cooling circuit can be supplied with tap water. The tap water flows only when the varistor temperature reaches a temperature of 45 C.