Scintillation counter and wire chamber front end modules for high energy physics experiments

Baldin, Boris ; DalMonte, Lou ; /Fermilab

关键词: ACCURACY;    AMPLIFIERS;    CONNECTORS;    DIGITIZERS;    FERMILAB;    HIGH ENERGY PHYSICS;    PHOSPHORS;    PHOTOMULTIPLIERS;    PLASTICS;    RESOLUTION;    SCINTILLATION COUNTERS;    SENSITIVITY;    TESTING;    TIME MEASUREMENT Instrumentation;   

DOI  :  10.2172/1005351
RP-ID  :  FERMILAB-TM-2483-E
PID  :  OSTI ID: 1005351
Others  :  TRN: US1101125

美国|英语

来源: SciTech Connect

【 摘 要 】

This document describes two front-end modules developed for the proposed MIPP upgrade (P-960) experiment at Fermilab. The scintillation counter module was developed for the Plastic Ball detector time and charge measurements. The module has eight LEMO 00 input connectors terminated with 50 ohms and accepts negative photomultiplier signals in the range 0.25...1000 pC with the maximum input voltage of 4.0 V. Each input has a passive splitter with integration and differentiation times of {approx}20 ns. The integrated portion of the signal is digitized at 26.55 MHz by Analog Devices AD9229 12-bit pipelined 4-channel ADC. The differentiated signal is discriminated for time measurement and sent to one of the four TMC304 inputs. The 4-channel TMC304 chip allows high precision time measurement of rising and falling edges with {approx}100 ps resolution and has internal digital pipeline. The ADC data is also pipelined which allows deadtime-less operation with trigger decision times of {approx}4 {micro}s. The wire chamber module was developed for MIPP EMCal detector charge measurements. The 32-channel digitizer accepts differential analog signals from four 8-channel integrating wire amplifiers. The connection between wire amplifier and digitizer is provided via 26-wire twist-n-flat cable. The wire amplifier integrates input wire current and has sensitivity of 275 mV/pC and the noise level of {approx}0.013 pC. The digitizer uses the same 12-bit AD9229 ADC chip as the scintillator counter module. The wire amplifier has a built-in test pulser with a mask register to provide testing of the individual channels. Both modules are implemented as a 6Ux220 mm VME size board with 48-pin power connector. A custom europack (VME) 21-slot crate is developed for housing these front-end modules.