Tailored Materials for High Efficiency CIDI Engines

Grant, G.J. ; Jana, S.

关键词: ALLOYS;    ALUMINIUM;    CARBON;    CARBON FIBERS;    COMBUSTION;    COMPRESSION;    DIESEL ENGINES;    EFFICIENCY;    ENERGY EFFICIENCY;    ENGINES;    FIBERS;    FRACTURE PROPERTIES;    FRICTION;    FUEL CONSUMPTION;    GRAIN REFINEMENT;    IGNITION;    IMPLEMENTATION;    LIFETIME;    MECHANICAL PROPERTIES;    NANOTUBES;    PISTONS;    STEELS;    SUBSTRATES;    TESTING;    THERMAL FATIGUE;   

DOI  :  10.2172/1038138
RP-ID  :  PNNL-21262
PID  :  OSTI ID: 1038138
Others  :  TRN: US201208%%561

美国|英语

来源: SciTech Connect

【 摘 要 】

The overall goal of the project, Tailored Materials for High Efficiency Compression Ignition Direct Injection (CIDI) Engines, is to enable the implementation of new combustion strategies, such as homogeneous charge compression ignition (HCCI), that have the potential to significantly increase the energy efficiency of current diesel engines and decrease fuel consumption and environmental emissions. These strategies, however, are increasing the demands on conventional engine materials, either from increases in peak cylinder pressure (PCP) or from increases in the temperature of operation. The specific objective of this project is to investigate the application of a new material processing technology, friction stir processing (FSP), to improve the thermal and mechanical properties of engine components. The concept is to modify the surfaces of conventional, low-cost engine materials. The project focused primarily on FSP in aluminum materials that are compositional analogs to the typical piston and head alloys seen in small- to mid-sized CIDI engines. Investigations have been primarily of two types over the duration of this project: (1) FSP of a cast hypoeutectic Al-Si-Mg (A356/357) alloy with no introduction of any new components, and (2) FSP of Al-Cu-Ni alloys (Alloy 339) by physically stirring-in various quantities of carbon nanotubes/nanofibers or carbon fibers. Experimental work to date on aluminum systems has shown significant increases in fatigue lifetime and stress-level performance in aluminum-silicon alloys using friction processing alone, but work to demonstrate the addition of carbon nanotubes and fibers into aluminum substrates has shown mixed results due primarily to the difficulty in achieving porosity-free, homogeneous distributions of the particulate. A limited effort to understand the effects of FSP on steel materials was also undertaken during the course of this project. Processed regions were created in high-strength, low-alloyed steels up to 0.5 in. deep that showed significant grain refinement and homogeneous microstructures favorable to increased fracture toughness and fatigue performance. The final tasks of the project demonstrated that the FSP concept can be applied to a relevant part geometry by fabricating diesel piston crowns with FSP regions applied selectively to the edge of the bowl rim. This area of the piston typically suffers from conditions at high PCP that cause severe thermal fatigue issues. It is expected that, given the data from coupon testing, the durability of pistons modified by FSP will allow much higher fatigue lifetime and potentially also greater resistance to elevated stress-level effects on fatigue.