Effect of polarizations on Sn-Zn solders alloys in alkaline electrolyte

JOURNAL OF ALLOYS AND COMPOUNDS

卷:606

Article

Nazeri, Muhammad Firdaus Mohd^1,2  Ismail, Ahmad Badri¹  Mohamad, Ahmad Azmin¹ 

[1] Univ Sains Malaysia, Sch Mat & Mineral Resources Engn, Nibong Tebal 14300, Penang, Malaysia

[2] Univ Malaysia Perlis, Sch Mat Engn, Kangar 02600, Perlis, Malaysia

关键词: Sn-9Zn;    Solder;    Corrosion;    Scan rate;    Mechanical properties;   

DOI  :  10.1016/j.jallcom.2014.04.034

来源: Elsevier

【 摘 要 】

The corrosion properties of Sn-9Zn lead-free solder was studied through potentiodynamic polarization in 6 M potassium hydroxide at different scanning rates. The corrosion rates of Sn-9Zn solder remained nearly constant at 2.1 X 10 (4) A cm (2) from scan rates of 2.0 mV s (1) to 3.5 mV s (1) before significantly increasing as the rates increased to higher than 3.5 mV s (1). The morphological analysis showed that two distinctive structures of a lamellar-like groove and irregularly shaped corrosion product compounds co-existed on the solder surface after being polarized at different rates. In addition, phase and elemental analyses revealed the formation of mixed corrosion products of SnO, SnO2, and ZnO on the surface after polarization. Moreover, the ultimate tensile stress endured by the solder joint decreased by 26% after polarization. (C) 2014 Elsevier B.V. All rights reserved.

【 授权许可】

Free