Nonlinear analysis of compressed elastic thin films on elastic substrates: From wrinkling to buckle-delamination

INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES

卷:51

Article

Pan, Kui^1,2  Ni, Yong^1,2  He, Linghui^1,2  Huang, Rui³ 

[1] Univ Sci & Technol China, CAS Key Lab Mech Behav & Design Mat, Hefei 230026, Anhui, Peoples R China

[2] Univ Sci & Technol China, Dept Modern Mech, Hefei 230026, Anhui, Peoples R China

[3] Univ Texas Austin, Dept Aerosp Engn & Engn Mech, Austin, TX 78712 USA

关键词: Thin film;    Buckling;    Delamination;    Interface;   

DOI  :  10.1016/j.ijsolstr.2014.07.005

来源: Elsevier

【 摘 要 】

Nonlinear buckling of elastic thin films on compliant substrates is studied by modeling and simulations to reveal the roles of pre-strain, elastic modulus ratio, and interfacial properties in morphological transition from wrinkles to buckle-delamination blisters. The model integrates an interfacial cohesive zone model with the Foppl-von Karman plate theory and Green function method within the general framework of energy minimization. A kinetics approach is developed for numerical simulations. Subject to a uniaxial pre-strain, the numerical simulations confirm the analytically predicted critical conditions for onset of wrinkling and wrinkle-induced delamination, with which a phase diagram is constructed. It is found that, with increasing pre-strain, the equilibrium configuration evolves from flat to wrinkles, to concomitant wrinkles and buckle-delamination, and to an array of parallel straight blisters. The height and width of the buckle-delamination blisters can be approximately described by a set of scaling laws with respect to the pre-strain and interfacial toughness. Subject to an equi-biaxial pre-strain, the critical conditions are determined numerically to construct a similar phase diagram for the buckling modes. Moreover, by varying the pre-strain, modulus ratio, and interfacial toughness, a rich variety of equilibrium configurations are simulated, including straight blisters, and network blisters with or without wrinkles. These results provide considerable insight into diverse surface patterns in layered material systems as a result of the mechanical interactions between the film and the substrate through their interface, which suggests potential control parameters for designing specific surface patterns. (C) 2014 Elsevier Ltd. All rights reserved.

【 授权许可】

Free