Trileucine as a dispersibility enhancer of spray-dried inhalable microparticles

JOURNAL OF CONTROLLED RELEASE

卷:336

Article

Ordoubadi, Mani¹  Gregson, Florence K. A.²  Wang, Hui¹  Carrigy, Nicholas B.³  Nicholas, Mark⁴  Gracin, Sandra⁴  Lechuga-Ballesteros, David³  Reid, Jonathan P.²  Finlay, Warren H.¹  Vehring, Reinhard¹ 

[1] Univ Alberta, Dept Mech Engn, 10-203 Donadeo Innovation Ctr Engn,9211 116th St, Edmonton, AB T6G 1H9, Canada

[2] Univ Bristol, Sch Chem, Bristol, Avon, England

[3] AstraZeneca, Inhalat Prod Dev Pharmaceut Technol & Dev, Operat, South San Francisco, CA USA

[4] AstraZeneca, Inhalat Prod Dev Pharmaceut Technol & Dev, Operat, Gothenburg, Sweden

关键词: Spray drying;    Trileucine;    Surface activity;    Particle engineering;    Particle formation;   

DOI  :  10.1016/j.jconrel.2021.06.045

来源: Elsevier

【 摘 要 】

The formation of trileucine-containing spray-dried microparticles intended for pulmonary delivery was studied in depth. A single-particle method was employed to study the shell formation characteristics of trileucine in the presence of trehalose as a glass former, and an empirical correlation was proposed to predict the instance of shell formation. A droplet chain instrument was used to produce and collect monodisperse particles to examine morphology and calculate particle density for different levels of trileucine. It was observed that the addition of only 0.5 mg/mL (10% w/w) trileucine to a trehalose system could lower dried particle densities by approximately 1 g/cm(3). In addition, a laboratory-scale spray dryer was used to produce batches of trileucine/trehalose powders in the respirable range. Raman spectroscopy demonstrated that both components were completely amorphous. Scanning electron microscopy and time-of-flight secondary ion mass spectrometry were used to study the particle morphologies and surface compositions. For all cases with trileucine, highly rugose particles with trileucine coverages of more than 60% by mass were observed with trileucine feed fractions of as little as 2% w/w. Moreover, it was seen that at lower trileucine content, smaller and larger particles of a polydisperse powder had slightly different surface compositions. The surface activity of trileucine was also modeled via a modified form of the diffusion equation inside an evaporating droplet that took into account initial surface adsorption and eventual surface desorption due to droplet shrinkage. Finally, using the Flory-Huggins theory, it was estimated that at room temperature, liquid-liquid phase separation would start when the trileucine reached an aqueous concentration of about 18 mg/mL. Besides the surface activity of trileucine, this low concentration was assumed to explain the substantial effect of trileucine on the morphology of spray-dried particles due to early phase separation. The methodology proposed in this study can be used in the rational design of trileucine-containing microparticles.

【 授权许可】

Free