Effects of iso-octane/ethanol blend ratios on the observance of negative temperature coefficient behavior within the Ignition Quality Tester

FUEL

卷:186

Article

Bogin, Gregory E., Jr.¹  Luecke, Jon²  Ratcliff, Matthew A.²  Osecky, Eric¹  Zigler, Bradley T.² 

[1] Colorado Sch Mines, Golden, CO 80401 USA

[2] Natl Renewable Energy Lab, Golden, CO USA

关键词: IQT;    Iso-octane;    Ethanol;    Ignition;    NTC;    Fuel blends;   

DOI  :  10.1016/j.fuel.2016.08.021

来源: Elsevier

【 摘 要 】

An ignition delay study investigating the reduction in low temperature heat release (LTHR) and negative temperature coefficient (NTC) region with increasing ethanol concentration in binary blends of ethanol/isooctane was conducted in the Ignition Quality Tester (IQT). The IQT is advantageous for studying multi component fuels such as iso-octane/ethanol which are difficult to study at lower temperatures covering the NTC region in traditional systems (e.g., shock tubes, rapid compression machines, etc.). The high octane numbers and concomitant long ignition delay times of ethanol and iso-octane are ideal for study in the IQT allowing the system to reach a quasi-homogeneous mixture; allowing the effect of fuel chemistry on ignition delay to be investigated with minimal impact from the fuel spray due to the relatively long ignition times. NTC behavior from iso-octane/ethanol blends was observed for the first time using an IQT. Temperature sweeps of iso-octane/ethanol volumetric blends (100/0, 90/10, 80/20, 50/50, and 0/100) were conducted from 623 to 993 K at 0.5, 1.0 and 1.5 MPa and global equivalence ratios ranging from 0.7 to 1.0. Ignition of the iso-octane/ethanol blends in the IQT was also modeled using a 0-D homogeneous batch reactor model. Significant observations include: (1) NTC behavior was observed for ethanol/isooctane fuel blends up to 20% ethanol. (2) Ethanol produced shorter ignition delay times than isooctane in the high temperature region. (3) The initial increase in ethanol from 0% to 10% had a lesser impact on ignition delay than increasing ethanol from 10% to 20%. (4) The 0-D model predicts that at 0.5 and 1.0 MPa ethanol produces the shortest ignition time in the high-temperature regime, as seen experimentally. (C) 2016 Elsevier Ltd. All rights reserved.

【 授权许可】

Free