Hydrogen sensors based on 2D WO3 nanosheets prepared by anodization

SENSORS AND ACTUATORS B-CHEMICAL

卷:251

Article

Rahmani, Mohammad Bagher¹  Yaacob, Mohd Hanif²  Sabri, Ylias Mohammad³ 

[1] Shahrood Univ Technol, Dept Phys, Shahrood 3619995161, Semnan, Iran

[2] Univ Putra Malaysia, Fac Engn, Wireless & Photon Network Res Ctr, Upm Serdang 43400, Selangor, Malaysia

[3] RMIT Univ, CAMIC, Sch Sci, Melbourne, Vic 3001, Australia

关键词: Hydrogen;    2D nanostructures;    Gas sensing;    Anodization;    Tungsten trioxide;    Surface properties;   

DOI  :  10.1016/j.snb.2017.05.029

来源: Elsevier

【 摘 要 】

Two dimensional tungsten trioxide (WO3) films made of nanosheets were prepared using high temperature anodization of tungsten (W) thin films. The W thin films were deposited by R.F. magnetron sputtering onto quartz substrates and then anodized at 50 degrees C in an aqueous solution containing 1.5 M HNO3. The structural and morphological properties of the prepared films were fully characterized prior to employing them for hydrogen gas sensing application. The hydrogen gas sensing performance of WO3 thin films was investigated at different temperatures through the measurement of conductance changes upon gas exposure. Hydrogen gas exposure resulted in the intercalation and subsequent reduction of WO3 sheets, changing the charge carrier concentration and hence the conductivity of the films. The fabricated sensors were found to exhibit excellent sensitivity and repeatability when they were exposed to hydrogen gas while using air as the carrier gas. The effects of different operating temperatures on the sensitivity of the devices were studied in the range of 20-250 degrees C. The dynamic response of the 2D WO3 nanosheets based sensors at different operating temperatures are presented and discussed. (C) 2017 Elsevier B.V. All rights reserved.

【 授权许可】

Free