Cyclic mechanical behaviour of Sn3.0Ag0.5Cu alloy under high temperature isothermal ageing

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

卷:528

Article

Dompierre, B.^1,2,3,4  Aubin, V.^2,3,4  Charkaluk, E.^2,4  Maia Filho, W. C.¹  Brizoux, M.¹ 

[1] Thales Corp Serv SAS, Engn & Proc Management, F-92366 Meudon, France

[2] Univ Lille Nord France, F-59000 Lille, France

[3] ECLille, LML, F-59650 Villeneuve Dascq, France

[4] CNRS, UMR 8107, F-59650 Villeneuve Dascq, France

关键词: Ageing;    Grain growth;    Hardness;    Cyclic tests;    Polarised light microscopy;   

DOI  :  10.1016/j.msea.2011.03.001

来源: Elsevier

【 摘 要 】

For SnAgCu alloys, the results of previous studies suggest that high-temperature thermal ageing causes quick and significant deterioration of their mechanical properties. However, the acceleration law of thermal ageing and the relationship between thermal ageing and the cyclic mechanical behaviour remain unknown. The aim of this study was to investigate the influence of isothermal ageing on the cyclic mechanical behaviour of Sn3.0Ag0.5Cu. First, ageing conditions were defined by taking into account the in-field operational conditions. Then, for all ageing conditions (75 degrees C, 125 degrees C and 150 degrees C up to 6500 h), the Vickers hardness was measured and the changes in this value were analysed during thermal ageing. At the same time, cross-polarised light microscopy observations on the same samples demonstrated the relation between the decrease in hardness and the changes in the microstructure for various samples. Finally, reversed mechanical cyclic tests were carried out at room temperature on specimens before and after ageing (125 degrees C, 500 h) in various conditions (strain rate/strain amplitude/dwell time). (C) 2011 Elsevier B.V. All rights reserved.

【 授权许可】

Free