Influence of the sintering atmosphere on the tensile properties of MIM-processed Ti 45Al 5Nb 0.2B 0.2C

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

卷:552

Article

Limberg, W.¹  Ebel, T.¹  Pyczak, F.¹  Oehring, M.¹  Schimansky, F. P.¹ 

[1] Helmholtz Zentrum Geesthacht, Inst Mat Res, Ctr Mat & Coastal Res, D-21502 Geesthacht, Germany

关键词: Titanium aluminides;    Metal injection moulding;    Aluminium evaporation;    Porosity;    Tensile properties;   

DOI  :  10.1016/j.msea.2012.05.047

来源: Elsevier

【 摘 要 】

In this study tensile test specimens were produced by metal injection moulding (MIM) of gas-atomised TNB-V5 alloy powder with the nominal composition Ti 45Al 5Nb 0.2B 0.2C (at.%). The specimens were sintered at 1500 degrees C under different atmospheres. The influence of the sintering atmosphere and the sintering time on the tensile properties, the microstructure and Al-sublimation were investigated. The residual porosity of the specimens increased proportionally with the applied argon gas pressure during sintering from 0.1% for vacuum to 1.1% for 80 kPa. Nevertheless, no relationship between the sintering pressure and the mechanical properties was found and ultimate tensile strengths (UTS) between 625 and 630 MPa with plastic elongations of 0.15-0.19% at room temperature were determined. (C) 2012 Elsevier B.V. All rights reserved.

【 授权许可】

Free