The Use of Thermography in Preliminary Research on Temperature of Burnishing

Journal of KONBiN

article

Justyna Molenda¹  Adam Charchalis¹ 

[1] Gdynia Maritime University

关键词: burnishing process;    IR thermography;    plastic working;    shaft working;    finishing working;   

DOI  :  10.2478/jok-2022-0020

学科分类：工程和技术（综合）

来源: Instytut Techniczny Wojsk Lotniczych / Air Force Institute of Technology

【 摘 要 】

The paper presents the methodology and results of experimental works concerning temperature of burnishing process. The research was carried out during disk burnishing of external cylindrical surfaces on a universal lathe CDS 6250 BX-1000 with severe parameters. As workpiece material steel S235JR has been selected. For temperature measurements infrared thermography method was chosen. This technique has a lot of advantages, the main is that it is non-contact technique and therefore there is no disturbance of the temperature field. In presented research infrared camera E95 produced by FLIR® Systems Inc. was used. Test results indicates the slight influence of process parameters on burnishing temperature.

【 授权许可】

Unknown