A large-scale microelectromechanical-systems-based silicon photonics LiDAR

Article

关键词: OPTICAL PHASED-ARRAY;    BEAM-STEERING DEVICE;    SWITCHES;   

DOI  :  10.1038/s41586-022-04415-8

来源: SCIE

【 摘 要 】

Three-dimensional (3D) imaging sensors allow machines to perceive, map and interact with the surrounding world(1). The size of light detection and ranging (LiDAR) devices is often limited by mechanical scanners. Focal plane array-based 3D sensors are promising candidates for solid-state LiDARs because they allow electronic scanning without mechanical moving parts. However, their resolutions have been limited to 512 pixels or smaller(2). In this paper, we report on a 16,384-pixel LiDAR with a wide field of view (FoV, 70 degrees x 70 degrees), a fine addressing resolution (0.6 degrees x 0.6 degrees), a narrow beam divergence (0.050 degrees x 0.049 degrees) and a random-access beam addressing with sub-MHz operation speed. The 128 x 128-element focal plane switch array (FPSA) of grating antennas and microelectromechanical systems (MEMS)-actuated optical switches are monolithically integrated on a 10 x 11-mm(2) silicon photonic chip, where a 128 x 96 subarray is wire bonded and tested in experiments. 3D imaging with a distance resolution of 1.7 cm is achieved with frequency-modulated continuous-wave (FMCW) ranging in monostatic configuration. The FPSA can be mass-produced in complementary metal-oxide-semiconductor (CMOS) foundries, which will allow ubiquitous 3D sensors for use in autonomous cars, drones, robots and smartphones.

【 授权许可】

Free