期刊论文详细信息
Jurnal Nasional Teknik Elektro
Pengaturan Keseimbangan Pengisian dan Pengosongan Baterai Asam Timbal
Mochammad Rismansyah1  Refdinal Nazir1 
[1] Jurusan Teknik Elektro, Fakultas Teknik, Universitas Andalas;
关键词: Lead-acid Battery;    mosfet;    charging and discharging;    arduino uno microcontroller;   
DOI  :  10.20449/jnte.v5i2.265
来源: DOAJ
【 摘 要 】

In this paper proposed a system of balance settings for charging and discharging the lead-acid battery using a microcontroller arduino uno 16U2. The calculation of battery capacity using the method of As (Ampere-second). Before this is done, the value of the energy stored in the battery is calculated using the relationship between the battery capacity (SOC) and the open-circuit voltage of the battery. The microcontroller will do the calculations for the system running using any current relationships in the system. Settings are separated between setting the maximum point and minimum point battery battery. Setting the maximum point guard of excess charging batteries. When the battery is full, the current discharge / disposal will flow which prevents the battery charging when it reaches the maximum point. 0153 constant exhaust flow set point A. Setting minimum keep the battery from the void (lack of energy). Load will not get a good supply of energy or battery charger when the battery below the minimum point because the charger is only charging the battery to pass the minimum point. This system uses the point of 11.67% with a minimum capacity of 50 Ah battery. System settings are made has managed to keep the battery from overload conditions and under loading.

【 授权许可】

Unknown   

  文献评价指标  
  下载次数:0次 浏览次数:0次