Numerical Simulation of Residual Stresses and Distortions of T-Joint Welding for Bridge Construction Application

Communications

Marek Patek¹  Radoslav Konar¹  Michal Sventek² 

[1] Department of Technological Engineering, Faculty of Mechanical Engineering, University of Zilina, Slovakia;MONT IRP, s.r.o., Zilina, Slovakia;

关键词: distortions;    finite element method;    residual stress;    sysweld;    welding simulation;   

DOI  :  10.26552/com.C.2016.1A.75-80

来源: DOAJ

【 摘 要 】

Prediction of the distortions and residual stresses of the welded steel structures is still very important to reduction of the costs, mainly during the optimization of welding process. If there is necessity of the higher welding current to ensure weld penetration, distortions might be influenced by appropriate welding sequence. During optimization process, numerical analysis of welding process, based on finite element method, can be used to prediction of distortions at different welding sequences without necessity of preparing high amount of experimental samples. Numerical simulation of T-joint welding process is presented in this article, together with verification of the analysis by thermocouple measurements and contactless measurement of distortions.

【 授权许可】

Unknown