CHANGES IN THE SURFACE LAYER OF ROLLED BEARING STEEL

Acta Polytechnica

Josef Chladil¹  Oskar Zemčík¹  Josef Sedlák¹ 

[1] Brno University of Technology

关键词: bearing steel;    roller burnishing;    finite element method;    residual austenite;    residual stress;   

DOI  :  

来源: Czech Technical University in Prague, Faculty of M

【 摘 要 】

This paper describes changes observed in bearing steel due to roller burnishing. Hydrostatic roller burnishing was selected as the most suitable method for performing roller burnishing on hardened bearing steel. The hydrostatic roller burnishing operation was applied as an additional operation after standard finishing operations. All tests were performed on samples of 100Cr6 material (EN 10132-4), and changes in the surface layer of the workpiece were then evaluated. Several simulations using finite element methods were used to obtain the best possible default parameters for the tests. The residual stress and the plastic deformation during roller burnishing were major parameters that were tested.

【 授权许可】

Unknown