Applicability of carbothermic reduction for upgrading Sri Lankan ilmenite ores: towards converting ilmenite into synthetic rutile by mechanical activation

Bulletin of the National Research Centre

T. Dilmi. U. Wijewardhana¹  Amila Sandaruwan Ratnayake¹ 

[1] Faculty of Applied Sciences, Uva Wellassa University;

关键词: Heavy minerals;    Sri Lanka;    Ilmenite;    Synthetic rutile;    Value addition;    Carbothermic reduction;   

DOI  :  10.1186/s42269-021-00608-9

来源: DOAJ

【 摘 要 】

Abstract Background Ilmenite and rutile are naturally occurring titanium-bearing heavy minerals. Sri Lanka consists of ilmenite and rutile in placer deposits mainly along the northeast coast. The commercial value of rutile is higher than ilmenite. Therefore, the current study focuses to upgrade Sri Lankan ilmenite ores using commercially available activated carbon as a reducing agent. Ilmenite fraction was initially separated from raw beach sand using an industrial-scale magnetic separator (Wet high-intensity magnetic separator: sixteen pole model). The mixtures of ilmenite and activated carbon (4 to 1 ratio by weight) were milled using a planetary ball mill for one to four hours at one-hour intervals. Results The milled samples were subsequently heated for two hours continuously at temperatures of 800 °C, 900 °C, 1000 °C, 1100 °C, and 1200 °C, respectively. Initial and annealed samples were analysed using X-ray diffraction (XRD), Fourier-transform infrared (FTIR) spectroscopy, and X-ray fluorescence (XRF) analyses. XRD pattern of the initial sample was characterized by less percentage of rutile (TiO2) peaks and low crystallinity. However, the number of rutile peaks and crystallinity were increased with respective milling hours and annealed temperature. Besides, XRD analysis indicates a higher number of sharp and intense rutile and elemental iron peaks in the samples annealed above 1000 °C. FTIR analysis of raw ilmenite indicates mainly stretching vibrations of Fe–O. However, vibrational spectral bands around 700 cm−1 in samples annealed above 1000 °C are assigned to Ti–O–Ti stretching vibrations. High TiO2 and TiO2 + Fe2O3 (total) wt. (%) can also be observed in samples annealed above 1000 °C. Conclusions The optimum conditions for carbothermic reduction were obtained at 4 h of ball milling of ilmenite with activated carbon and continuously annealing at 1000 °C for 2 h. Carbothermic reduction is applicable to upgrade Sri Lankan ilmenite ores, and thus this method adds value to heavy mineral resources in Sri Lanka.

【 授权许可】

Unknown