Effect of phosphoric acid content on the microstructure and compressive strength of phosphoric acid-based metakaolin geopolymers

Heliyon

Bingxin Liu¹  Xingchang Yu²  Li Gao²  Jianwei Yu²  Youxiong Zheng²  Yan Tang² 

[1] Corresponding author.;Qinghai Provincial Key Laboratory of New Light Alloys, Qinghai Provincial Engineering Research Center of High Performance Light Metal Alloys and Forming, Qinghai University, Xining, 810016, PR China;

关键词: Materials science;    Materials chemistry;    Metakaolin;    Phosphoric acid;    Geopolymers;    Amorphous phase;   

DOI  :  

来源: DOAJ

【 摘 要 】

The phosphoric acid-based metakaolin geopolymers were prepared by regulating H3PO4/Al2O3 ratios. X-ray diffraction (XRD), thermogravimetry and differential scanning calorimeter (TG-DSC), Fourier transform infrared spectroscopy (FTIR) and scanning electron microscopy (SEM) were used to determine the reaction process and phase formation. The results showed that the metakaolin calcined from Kaolinite mainly consisted of quartz crystalline phase and amorphous phase. The diffraction peak for quartz obviously became lower with the increasing of H3PO4/Al2O3 ratios. The excessive quartz from metakaolin did not totally take part in the chemical reaction. The polymeric structure of -P-O-Si-O-Al-O constitutes the main building block of phosphoric acid-based metakaolin geopolymeric structure. The optimized compressive strength was 29 ± 2 MPa with H3PO4/Al2O3 molar ratio = 1.3:1. The simulation of the total deformation under 29 MPa load and the total heat flux at 1400 °C of the phosphoric acid-based metakaolin geopolymers with H3PO4/Al2O3 molar ratio of 1.3:1 based on finite element method verified the failure mechanism and the excellent thermal stability at high temperature.

【 授权许可】

Unknown