Effect of Printing Parameters on the Thermal and Mechanical Properties of 3D-Printed PLA and PETG, Using Fused Deposition Modeling

Polymers

Chieh-Yu Pan¹  Chao-Jung Lai²  Ming-Hsien Hsueh³  Shi-Hao Wang³  Yu-Shan Zeng³  Chia-Hsin Hsieh³  Wen-Chen Huang⁴ 

[1] Department and Graduate Institute of Aquaculture, National Kaohsiung University of Science and Technology, Kaohsiung 811213, Taiwan;Department of Fashion Design and Management, Tainan University of Technology, Tainan 71002, Taiwan;Department of Industrial Engineering and Management, National Kaohsiung University of Science and Technology, Kaohsiung 807618, Taiwan;Department of Information Management, National Kaohsiung University of Science and Technology, Kaohsiung 824005, Taiwan;

关键词: 3D printing;    FDM;    PLA;    PETG;    mechanical properties;    thermal deformation;   

DOI  :  10.3390/polym13111758

来源: DOAJ

【 摘 要 】

Fused Deposition Modeling (FDM) can be used to manufacture any complex geometry and internal structures, and it has been widely applied in many industries, such as the biomedical, manufacturing, aerospace, automobile, industrial, and building industries. The purpose of this research is to characterize the polylactic acid (PLA) and polyethylene terephthalate glycol (PETG) materials of FDM under four loading conditions (tension, compression, bending, and thermal deformation), in order to obtain data regarding different printing temperatures and speeds. The results indicated that PLA and PETG materials exhibit an obvious tensile and compression asymmetry. It was observed that the mechanical properties (tension, compression, and bending) of PLA and PETG are increased at higher printing temperatures, and that the effect of speed on PLA and PETG shows different results. In addition, the mechanical properties of PLA are greater than those of PETG, but the thermal deformation is the opposite. The above results will be a great help for researchers who are working with polymers and FDM technology to achieve sustainability.

【 授权许可】

Unknown