Turning Research of Additive Laser Molten Stainless Steel 316L Obtained by 3D Printing

Materials

Fabian Laufer¹  Sebastian Hichert¹  Andrzej Matras²  Magdalena Machno²  Wojciech Zębala²  Łukasz Ślusarczyk²  Grzegorz Struzikiewicz² 

[1] Institute of Manufacturing Technology and Quality Management (IFQ), Faculty of Mechanical Engineering, Otto von Guericke University Magdeburg, 39106 Magdeburg, Germany;Production Engineering Institute, Mechanical Faculty, Cracow University of Technology, 31-155 Kraków, Poland;

关键词: 316L stainless steel;    sintered materials;    turning;    SLM;   

DOI  :  10.3390/ma12010182

来源: DOAJ

【 摘 要 】

This paper presents the characteristic of 316L steel turning obtained by 3D printing. The analysis of the influence of turning data on the components of the total cutting force, surface roughness and the maximum temperature values in the cutting zone are presented. The form of chips obtained in the machining process was also analyzed. Statistical analysis of the test results was developed using the Taguchi method.

【 授权许可】

Unknown