Investigation of Micro Square Structure Fabrication by Applying Textured Cutting Tool in WEDM

Micromachines

Hui Zhang¹  Huaijiang Yang¹  Yongxin Sui¹  Quansong Li¹  Jianguo Zhang¹ 

[1] Engineering Research Center of Extreme Precision Optics, State Key Laboratory of Applied Optics, Changchun Institute of Optics, Fine Mechanics and Physics, Chinese Academy of Science, Changchun 130033, China;

关键词: textured tool cutting edge;    WEDM;    micro structure;    turning;   

DOI  :  10.3390/mi6101427

来源: DOAJ

【 摘 要 】

This paper studies micro structure fabrication by means of a textured tool cutting edge, which is manufactured by applying the wire cut electrical discharge machining (WEDM). Machining performance of the square structure fabrication on the tool cutting edge is investigated in the WEDM process, and the machining accuracy is explored in experimental analyses. In this proposed method, undesired overcut comes from the discharge between the processing debris and the side wall of the target structure. Furthermore, by applying the textured cutting tool, the target square structure is directly fabricated on the alumina workpiece with just a simple turning process, which verifies the feasibility of the proposed tool cutting edge textured method by applying the WEDM. This technology is expected to become a potential method for the mass production of micro structure surfaces in the future.

【 授权许可】

Unknown