Exergetic Performance of a PEM Fuel Cell with Laser-Induced Graphene as the Microporous Layer

Energies

Ioan Stamatin¹  Adriana Elena Balan¹  Viorel Ionescu²  Alexandra Maria Isabel Trefilov³ 

[1] 3NanoSAE Research Center, Faculty of Physics, University of Bucharest, 077125 Măgurele, Romania;Department of Physics and Electronics, Ovidius University of Constanța, 900527 Constanța, Romania;National Institute for Laser, Plasma and Radiation Physics (INFLPR), 077125 Măgurele, Romania;

关键词: exergy efficiency;    laser-induced graphene (LIG);    microporous layer;    proton exchange membrane fuel cell (PEM FC);    thermodynamic irreversibility;    voltage efficiency;   

DOI  :  10.3390/en14196232

来源: DOAJ

【 摘 要 】

The microporous layer (MPL) constitutes a critical component of the gas diffusion layer within the membrane electrode assembly (MEA) of a proton exchange membrane fuel cell (PEM FC). The MPL plays a fundamental role in various processes during FC operation: control of membrane humidification, heat distribution throughout the MEA, excess water removal from the cathode, and transportation of fuel to the reaction sites. Previously, we investigated the performance of a fuel cell unit employing an MPL based on laser-induced graphene (LIG) produced by the laser pyrolysis of polymeric (polyimide) substrates. The prototype LIG-based unit was tested over the typical range of relative humidity and temperature conditions. The polarization curves observed in that study displayed broad ohmic loss regions and high stability along the concentration loss regions, an interesting electrical behavior that justified developing the present voltage-current density study for the same FC prototype compared to one bearing a commercial pyrolytic carbon black MPL. The same operating conditions as in the first study were applied, in order to properly compare the performance efficiencies between the two systems; these are evaluated by considering the thermodynamic losses influence on the exergy efficiency, to exceed any limitations inherent in the classical energy efficiency analysis.

【 授权许可】

Unknown