Generic Type 3 Wind Turbine Model Based on IEC 61400-27-1: Parameter Analysis and Transient Response under Voltage Dips

Energies

Ángel Molina-García¹  Emilio Gómez-Lázaro²  Alberto Lorenzo-Bonache²  Andrés Honrubia-Escribano²  Francisco Jiménez-Buendía³ 

[1] Department of Electrical Engineering, Universidad Politécnica de Cartagena, 30202 Cartagena, Spain;Renewable Energy Research Institute and DIEEAC-EDII-AB, Universidad de Castilla-La Mancha, 02071 Albacete, Spain;Siemens Gamesa Renewable Energy, S.A., 31621 Pamplona, Spain;

关键词: DFIG;    generic model;    IEC 61400-27;    model validation;    study of sensitivity;    standard model;    wind turbine;   

DOI  :  10.3390/en10091441

来源: DOAJ

【 摘 要 】

This paper analyzes the response under voltage dips of a Type 3 wind turbine topology based on IEC 61400-27-1. The evolution of both active power and rotational speed is discussed in detail when some of the most relevant control parameters, included in the mechanical, active power and pitch control models, are modified. Extensive results are also included to explore the influence of these parameters on the model dynamic response. This work thus provides an extensive analysis of the generic Type 3 wind turbine model and provides an estimation of parameters not previously discussed in the specific literature. Indeed, the International Standard IEC 61400-27-1, recently published in February 2015, defines these generic dynamic simulation models for wind turbines, but does not provide values for the parameters to simulate the response of these models. Thus, there is a pressing need to establish correlations between IEC generic models and specific wind turbine manufacturer models to estimate suitable parameters for simulation purposes. Extensive results and simulations are also included in the paper.

【 授权许可】

Unknown