Frequency-Dependent Sonochemical Processing of Silicon Surfaces in Tetrahydrofuran Studied by Surface Photovoltage Transients

Molecules

Viktor Schlosser¹  Artem Podolian²  Oleg Korotchenkov²  Andriy Nadtochiy² 

[1] Department of Electronic Properties of Materials, Faculty of Physics, University of Vienna, A-1090 Wien, Austria;Faculty of Physics, Taras Shevchenko National University of Kyiv, 01601 Kyiv, Ukraine;

关键词: power ultrasound;    sonochemistry;    ultrasonic frequency;    silicon;    tetrahydrofuran;    surface photovoltage;   

DOI  :  10.3390/molecules26123756

来源: DOAJ

【 摘 要 】

The field of chemical and physical transformations induced by ultrasonic waves has shown steady progress during the past decades. There is a solid core of established results and some topics that are not thoroughly developed. The effect of varying ultrasonic frequency is among the most beneficial issues that require advances. In this work, the effect of sonication of Si wafers in tetrahydrofuran on the photovoltage performance was studied, with the specific goal of studying the influence of the varying frequency. The applied ultrasonic transducer design approach enables the construction of the transducer operating at about 400 kHz with a sufficient sonochemical efficiency. The measurements of the surface photovoltage (SPV) transients were performed on p-type Cz-Si(111) wafers. Sonication was done in tetrahydrofuran, methanol, and in their 3:1 mixture. When using tetrahydrofuran, the enhanced SPV signal (up to ≈80%) was observed due to increasing sonication frequency to 400 kHz. In turn, the signal was decreased down to ≈75% of the initial value when the frequency is lowered to 28 kHz. The addition of methanol suppressed this significant difference. It was implied that different decay processes with hydrogen decomposed from tetrahydrofuran could be attempted to explain the mechanism behind the observed frequency-dependent behavior.

【 授权许可】

Unknown