Direct Printing of a Multi-Layer Sensor on Pet Substrate for CO2 Detection

Energies

Cristian Lombardo¹  Salvatore Graziani¹  Vicenzo Marletta¹  Salvatore Baglio¹  Bruno Andò¹  Antonio Pollicino²  Chiara Gugliuzzo²  Giovanna Di Pasquale² 

[1] DIEEI University of Catania, v.le A. Doria 6, 95127 Catania, Italy;DII University of Catania, v.le A. Doria 6, 95127 Catania, Italy;

关键词: CO₂ monitoring;    inkjet printing;    gas sensor;    PEDOT/PSS;    graphene;    interdigited electrodes;    flexible substrate;   

DOI  :  10.3390/en12030557

来源: DOAJ

【 摘 要 】

The use of inexpensive gas sensors is a real need for many applications requiring the use of disposable sensors. This work deals with the realization and characterization of a low cost CO₂ sensor realized by rapid prototyping techniques. In particular, the sensor consists of a set of InterDigiTed electrodes, over which a double sensing layer made of PEDOT/PSS (CLEVIOS™ PHCV4, by H.C.Starck) and a solution of pristine graphene powder has been deposited. A silver nano-particle solution is used for inkjet printing the electrodes onto the PET (PolyEthylene Terephthalate) substrate, through a commercial inkjet printer. The sensing strategy is based on the variation of the electrical conductance of graphene due to gas molecules adsorption. The device responsivity observed in two different operating conditions (50 °C and 60 °C), is 4.0 µΩ/Ω/ppm and 4.7 µΩ/Ω/ppm. The corresponding values of the resolution are 400 ppm and 420 ppm. Main advantages of the developed sensor consist in the cost-effective fabrication techniques and the device flexibility, which are strategic for applications requiring disposable and shapeable devices to be installed into irregular surfaces.

【 授权许可】

Unknown