A New Current-Shaping Technique Based on a Feedback Injection Mechanism to Reduce VCO Phase Noise

Sensors

卷:21

Francisco Javier del Pino Suárez¹  Sunil Lalchand Khemchandani¹ 

[1] Departamento de Ingeniería Electrónica y Automática, Institute for Applied Microelectronics (IUMA), Universidad de Las Palmas de Gran Canaria, E-35017 Las Palmas de Gran Canaria, Spain;

关键词: LC-VCO;    CMOS;    phase noise;    current-shaping;    90 nm;    current tail;   

DOI  :  10.3390/s21196583

来源: DOAJ

【 摘 要 】

Inductor-capacitor voltage controlled oscillators (LC-VCOs) are the most common type of oscillator used in sensors systems, such as transceivers for wireless sensor networks (WSNs), VCO-based reading circuits, VCO-based radar sensors, etc. This work presents a technique to reduce the LC-VCOs phase noise using a new current-shaping method based on a feedback injection mechanism with only two additional transistors. This technique consists of keeping the negative resistance seen from LC tank constant throughout the oscillation cycle, achieving a significant phase noise reduction with a very low area increase. To test this method an LC-VCO was designed, fabricated and measured on a wafer using 90 nm CMOS technology with 1.2 V supply voltage. The oscillator outputs were buffered using source followers to provide additional isolation from load variations and to boost the output power. The tank was tuned to 1.8 GHz, comprising two 1.15 nH with 1.5 turns inductors with a quality factor (Q) of 14, a 3.27 pF metal-oxide-metal capacitor, and two varactors. The measured phase noise was −112 dBc/Hz at 1 MHz offset. Including the pads, the chip area is 750 × 850 $\mathsf{\mu }$m${}^2$.

【 授权许可】

Unknown