The Development of an UAV Borne Direct Georeferenced Photogrammetric Platform for Ground Control Point Free Applications

Sensors

Kai-Wei Chiang²  Meng-Lun Tsai¹ 

[1] id="af1-sensors-12-09161">Department of Geomatics, National Cheng-Kung University, No.1, University Road, Tainan 701, Taiwan; E-Mails: [e-mail] (K.-W.C.); [e-mail] (C.-H.C

关键词: direct georeferencing;    INS;    GPS;    UAV;   

DOI  :  10.3390/s120709161

来源: mdpi

【 摘 要 】

To facilitate applications such as environment detection or disaster monitoring, the development of rapid low cost systems for collecting near real time spatial information is very critical. Rapid spatial information collection has become an emerging trend for remote sensing and mapping applications. In this study, a fixed-wing Unmanned Aerial Vehicle (UAV)-based spatial information acquisition platform that can operate in Ground Control Point (GCP) free environments is developed and evaluated. The proposed UAV based photogrammetric platform has a Direct Georeferencing (DG) module that includes a low cost Micro Electro Mechanical Systems (MEMS) Inertial Navigation System (INS)/Global Positioning System (GPS) integrated system. The DG module is able to provide GPS single frequency carrier phase measurements for differential processing to obtain sufficient positioning accuracy. All necessary calibration procedures are implemented. Ultimately, a flight test is performed to verify the positioning accuracy in DG mode without using GCPs. The preliminary results of positioning accuracy in DG mode illustrate that horizontal positioning accuracies in the x and y axes are around 5 m at 300 m flight height above the ground. The positioning accuracy of the z axis is below 10 m. Therefore, the proposed platform is relatively safe and inexpensive for collecting critical spatial information for urgent response such as disaster relief and assessment applications where GCPs are not available.

【 授权许可】

CC BY   
© 2012 by the authors; licensee MDPI, Basel, Switzerland.