Improvement of continuous forming the "Conform" method

20th International Scientific and Research Conference "Metallurgy: Technologies, Innovation, Quality. Metallurgy-2017"

Fastikovskiy, A.R.^1 ; Selivanova, E.V.^1 ; Fedorov, A.A.^1 ; Peretyatko, V.N.^1 ; Evstifeev, V.V.^2 ; Efimov, O.Yu^3

Siberian State Industrial University, 42 Kirova street, Novokuznetsk

654007, Russia^1

Siberian State Automobile and Highway University, 5 Prospekt Mira, Omsk

64080, Russia^2

LLC pROMMEST, 4A per. Ulyany Gromovoy, St. Petersburg

191036, Russia^3

关键词: Bearing plate;    Continuous forming;    Slope angles;    Workpiece;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/411/1/012082/pdf
DOI  :  10.1088/1757-899X/411/1/012082

来源: IOP

【 摘 要 】

Improvements of continuous forming method "Conform" are offered, consisting in the possibility of changing the slope angle of the bearing plate relative to the wheel, allowing a number of restrictions to be removed, the setup and operation of the equipment to be substantially simplified. Conditions are determined according to which the workpiece capture and the mounting of the bearing plate at various angles are possible. The reliability of the dependences obtained is confirmed by the studies carried out on the laboratory installation.