Application of Taguchi Method in Investigating The Effect of Layer Thickness and Fill Angle on FDM Parts

3rd International Conference on Manufacturing, Material and Metallurgical Engineering

机械制造;材料科学;冶金学

Nor, Siti Maryam Md^1 ; Sudin, Mohd Nizam^1 ; Razali, Muhamad Farid Bin^1

Department of Design and Innovation, Faculty of Mechanical Engineering, Universiti Teknikal Malaysia Melaka, Centre for Advanced Research on Energy (CARe), Melaka, Malaysia^1

关键词: Acrylonitrile butadiene styrene;    Carbon fiber reinforced;    Fused deposition modeling;    Layer thickness;    Optimized parameter;    Signal to noise (S/N) ratios;    Stress performance;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/409/1/012018/pdf
DOI  :  10.1088/1757-899X/409/1/012018

学科分类：材料科学（综合）

来源: IOP

【 摘 要 】

This paper studies the effect of Layer Thickness and Fill Angle on tensile stress of Fused Deposition Modeling (FDM) parts for Acrylonitrile Butadiene Styrene (ABS) and Carbon Fiber Reinforced ABS (CFRABS) materials by using Taguchi Method, signal-to-noise (S/N) ratio analysis and Analysis of Variance (ANOVA). From the results, it was found that layer thickness contribute to the tensile stress performance of ABS and fill angle has significant effect on tensile stress of CFRABS. It can be concluded that the optimized parameter obtained in this study for both materials are 0.18mm layer thickness and 90° fill angle.